Version: v2.5.0

Network Settings

These instructions apply to an Ubuntu system. For different Linux distribution version the process to change the IP address may differ but it is required to reinstall Bitstreams

Updating IP Address

warning

DHCP is supported but not recommended, because if/when the address changes a script needs to be run to update the software.

SSH into the server, the default IP address is 192.168.1.23
```
ssh nvme@<ip address>
```
Edit the netplan file for the desired IP address. For more information see Netplan Examples.
```
sudo nano /etc/netplan/01-network-manager-all.yaml
```
When completed press CTL + x and press Enter.
Apply the changes to update the IP address configurations.
```
sudo netplan apply
```

Verify the new IP address.

ip a

In the below example the IP address was changed to 10.0.129.60

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
        valid_lft forever preferred_lft forever
    inet6 ::1/128 scope host
        valid_lft forever preferred_lft forever
2: eno1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
    link/ether 7c:c2:55:88:11:bc brd ff:ff:ff:ff:ff:ff
    inet 10.0.129.60/22 brd 10.0.131.255 scope global eno1
        valid_lft forever preferred_lft forever
    inet6 fe80::7ec2:55ff:fe88:11bc/64 scope link
        valid_lft forever preferred_lft forever
3: eno2: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN group default qlen 1000
    link/ether 7c:c2:55:88:11:bd brd ff:ff:ff:ff:ff:ff
4: docker0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue state DOWN group default
    link/ether 02:42:f2:6c:31:16 brd ff:ff:ff:ff:ff:ff
    inet 172.17.0.1/16 brd 172.17.255.255 scope global docker0
        valid_lft forever preferred_lft forever

Reinstall Bitstreams

Navigate to the Bitstreams directory for the currently running release.
```
cd ~/Bitstreams_Edge_vX.Y.Z_x86
```
Run the installer script with the new IP address.
Adding -y to the command will automatically accept the detault answers to any questions.
```
edge_quick_install.py <new_ip_address> http
```

Updating IP Address​

Reinstall Bitstreams​

Updating IP Address

Reinstall Bitstreams